For our second session and much of our first, we focused on creating the base and supporting pole for our model. This was done using simple MDF board at a few inches thick for sturdiness, cut into a square model base with enough room for the pole to be fit into a drilled hole in the base. The pole was made by measuring and sawing off a piece of metal rod then by bending it into an L shape using a hammer and vice, it was able to slot into a hole drilled into the base. This would be used to model the character around so that it was given support.
Here are some photographs of the model I chose to make from the design sheet shown earlier:
No comments:
Post a Comment